If there is latency (positive OR negative), it will be shown in the Latency Offset window of the I/O plugin. If everything is set up correctly, it will register the ping on Audio 1, Stereo Out and Out 3-4. In the I/O plugin, click the "Ping" button. In the Mixer Window click the "All" button.ġ0. ![]() On the Fireface, Logic's Output 4 must be routed to the Physical Output 4 of the unit.ĩ. I'm not familiar with the Phonic 808, but in the software Control Panel for my FireFace 400, there are faders for its physical Inputs, physical Outputs and DAW (Logic's) Outputs. On your audio interface, make sure Input 4 and Output 4 are not muted and their faders are up. Use an actual cable that you can touch and feel with your hands.Ĩ. Don't engage any fancy digital loopback stuff. On your audio interface, use a cable to connect Output 4 to Input 4. Set the I/O plugin's Output and Input to 4.ħ. Click on an insert slot of the Audio Channel Strip and open the I/O plugin.Ħ. Change the Output of the Audio Channel Strip back to Stereo Out. This automatically creates an Output 3-4 Channel Strip.Ĥ. Change the Output of the Audio Channel Strip to Output 3-4. Open an Empty Project from the Factory Templates.ģ. (This describes using input 4 and output 4 of your audio interface, but you can use any unused in/out.)ġ. The "Ping" version of determining recording latency I/O Plugin: Click on an insert slot and then Utility > I/O. It's good to know where that is, but I don't think that's your problem. The Plug-in Latency section is in the middle of the page. ![]() Go to Logic Pro > Preferences > Audio > General.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |